Timex Watch 359 095002 EU User Manual

W257 359-095002 EU  
THANK YOU FOR PURCHASING YOUR TIMEX® WATCH.  
Please read instructions carefully to understand how to operate your  
Timex® watch.  
FEATURES  
ALTIMETER SCALE  
BUTTON A  
(hundreds)  
(maximum altitude)  
UPPER  
RETROGRADE  
(thousands)  
CROWN  
LOWER RETROGRADE  
(units)  
BUTTON B  
(minimum altitude)  
BUTTON C  
(units)  
NOTE: Watch is shipped with guard around crown. Remove guard  
and push crown in to start. Altimeter must be calibrated before using  
to ensure accuracy and avoid improper altitude reading. See  
Altimeter Calibration section for complete details.  
SET DATE AND TIME  
Pull crown to MIDDLE position and turn until correct date appears.  
After setting date, pull crown all the way out and turn until correct  
time is shown. Ensure correct AM/PM setting by verifying that date  
changes at midnight, not noon. Push crown in when done. Adjust  
date after months with fewer than 31 days.  
INDICATOR HAND (4TH CENTER HAND) ADJUSTMENT  
Pull crown all the way out. The upper and lower retrograde hands  
reset to the start of their scales automatically. Indicator hand (4th  
center hand) should point to 12 o’clock. If it does not, press either A  
and/or B button to move hand until it points to 12 o’clock. A and B  
buttons move hand counterclockwise and clockwise, respectively.  
Hold button to move hand fast. Push crown in when done.  
ALTIMETER CALIBRATION  
Before use, the altimeter must be calibrated.  
Since an altimeter uses pressure to determine the altitude and  
pressure varies from place to place, it is important to set the  
altimeter to a known reference altitude value, or to a standard  
reference altitude of a given place. Sudden changes in pressure due  
to changes in weather can cause your altimeter reading to be off by  
+-100m (328 ft), even if your location has not changed. Recalibrate  
to a known altitude when drastic pressure changes occur.  
To calibrate the altimeter:  
1. Pull the crown to its middle position and wait for the indicator  
hands to stop moving.  
2. If the altimeter was OFF at the moment of crown pulling, the  
lower retrograde hand will point to the unit selected the last time  
the altimeter was used, otherwise the lower retrograde hand  
points to the current selected unit in altitude display. The 4th  
center hand and upper retrograde hand should point to the  
current altitude.  
3. Press A or B to move the 4th center hand counterclockwise or  
clockwise, respectively, until it points to the desired calibration  
altitude. Holding A or B will move the center hand more rapidly.  
The upper retrograde hand moves relative to the altitude value  
displayed by the 4th center hand.  
4. Push crown in when done.  
To change the unit from METERS to FEET or FEET to METERS, press  
C. If button C is not released within one second, changes made in  
calibration are discarded and the current altitude is displayed.  
ALTIMETER ON/OFF  
To turn the altimeter on, press C. The lower retrograde hand points  
to METERS. Using the markings on the top ring, the 4th center hand  
shows the current altitude’s hundreds and tens value with divisions  
every ten METERS/FEET. The upper retrograde hand shows the  
current altitude’s thousands value with divisions every one thousand  
METERS/FEET.  
To change the unit from METERS to FEET, press C a second time.  
To change the unit from FEET to METERS, press C twice (altimeter is  
turned off first then turned back on with the unit in METERS).  
To turn the altimeter off with the current unit set to FEET, press C.  
To turn the altimeter off with the unit set to METERS, press C twice  
(lower hand goes to FEET first before going to the OFF position).  
The watch will automatically turn the altimeter off after 60 minutes  
from activation.  
Example: Altitude=7580 ft  
Example: Altitude=2310 m  
ALTIMETER MIN/MAX ALTITUDE RECALL  
To view the maximum recorded altitude, press A. The lower retro-  
grade hand shows the unit of measure that the maximum altitude  
was recorded in if the altimeter was OFF at the moment of button  
press, otherwise it will show the maximum altitude using the current  
selected unit. The 4th center hand shows the maximum altitude’s  
hundreds and tens value with divisions every ten METERS/FEET. The  
upper retrograde hand shows the maximum altitude’s thousands  
value with divisions every one thousand METERS/FEET.  
The maximum recorded altitude is displayed for ten seconds. To  
extend the display duration for another ten seconds, press A before  
the previous ten second duration expires.  
To change the unit from METERS to FEET or FEET to METERS, press C.  
To view the minimum recorded altitude, press B. The lower retro-  
grade hand shows the unit of measure that the minimum altitude  
was recorded in if the altimeter was OFF at the moment of button  
press, otherwise it will show the minimum altitude using the current  
selected unit. The 4th center hand shows the minimum altitude’s  
hundreds and tens value with divisions every ten METERS/FEET. The  
upper retrograde hand shows the minimum altitude’s thousands  
value with divisions every one thousand METERS/FEET.  
The minimum recorded altitude is displayed for ten seconds. To  
extend the display duration for another ten seconds, press B before  
the previous ten second duration expires To change the unit from  
METERS to FEET or FEET to METERS, press C.  
WATER RESISTANCE  
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS  
ANY BUTTONS UNDER WATER.  
1. Watch is water-resistant only as long as lens, push buttons and  
case remain intact.  
2. Watch is not a diver watch and should not be used for diving.  
3. Rinse watch with fresh water after exposure to salt water.  
If your watch is water-resistant, meter marking or (O) is indicated.  
Water-Resistance Depth  
p.s.i.a. * Water Pressure Below Surface  
30m/98ft  
50m/164ft  
100m/328ft  
60  
86  
160  
*pounds per square inch absolute  
BATTERY  
Timex strongly recommends that a retailer or jeweler replace  
battery. Battery type is on watch back. If present, push/short inter-  
nal reset switch after replacing battery. Battery life estimates are  
based on certain assumptions regarding usage; battery life may vary  
depending on actual usage.  
DO NOT DISPOSE OF BATTERY IN FIRE. DO NOT RECHARGE. KEEP  
LOOSE BATTERIES AWAY FROM CHILDREN.  
INDIGLO® NIGHT-LIGHT  
Press button or crown to activate light.  
Electroluminescent technology used in the INDIGLO®  
night-light illuminates entire watch face at night and in low light  
conditions.  
BRACELET ADJUSTMENT  
Foldover Clasp Bracelet  
Find spring bar that connects bracelet to clasp. Using a pointed tool  
(Fig. 1), push spring bar in and gently twist bracelet to disengage.  
Determine wrist size, then insert spring bar in correct bottom hole  
(Fig. 2). Push down on spring bar, align with top hole and release to  
lock in place (Fig. 3).  
Fig. 1  
Fig. 3  
Fig. 2  
Bracelet Link Removal  
Removing Links: Place bracelet upright and  
insert pointed tool in opening of link. Push  
pin forcefully in direction of arrow until link is  
detached (pins are designed to be difficult to  
remove). Repeat until desired number of links  
are removed.  
Reassembly: Rejoin bracelet parts. Push pin back into link in oppo-  
site direction of arrow. Press pin down securely into bracelet until it  
is flush.  
Solid Link Bracelet  
Removing Links: Using a very small screwdriv-  
er, remove screws by  
turning counterclockwise. Repeat until desired  
number of links are removed. Do not remove  
links adjacent to clasp.  
Reassembly: Rejoin bracelet parts and insert  
screw in end of opening where it was removed. Turn screw clock-  
wise until tight and flush with bracelet.  
 

Tascam DVD Player DV D01U User Manual
Telex Projection Television PH 150 User Manual
Toshiba Network Card F Series User Manual
Toshiba Sprinkler 6F3B0253 User Manual
Toshiba Universal Remote 2358 User Manual
TRENDnet Switch TK 208K User Manual
Tricity Bendix Oven SB 415GR User Manual
Troy Bilt Yard Vacuum 24B 060F063 User Manual
Victor Technology Calculator 1240 2 Series User Manual
VocoPro Microphone VHF 38 User Manual