Timex Watch 141 095006 NA User Manual

W-187 141 095006 NA  
The Automatic Collection  
24 Hour Hand  
Minute Hand  
Hour Hand  
1
2
3
Power Indicator  
Calendar  
HOW TO SET THE TIME  
Unscrew crown all the way out and turn to correct time. Push crown in  
to restart.  
Watches with date: Note correct time of day (A.M. or P.M.) for proper  
date function. (Please see illustration above for 24-HR dial.)  
HOW TO SET “FAST DATE”  
3-Position Crown: Unscrew crown until you reach position “2” and turn  
counterclockwise until correct date appears.  
NOTE: Date may need to be manually  
1 2 3  
updated at the end of each month by fol-  
14  
lowing above procedure (otherwise it will  
continue to 31 and then roll over to 01  
each month).  
HOW TO WIND YOUR WATCH  
Turn crown in position 1 to begin winding clockwise.  
POWER RESERVE  
The watch is self-winding. If you wear your watch every day, there  
should be no need to wind it every 24 hours, unless the power reserve  
shows “LOW”.  
The maximum power reserve is at least 36 hours. The power reserve  
indicator shows you how much power remains. You should wind your  
watch when the indicator hand is near “LOW”.  
BRACELET ADJUSTMENT  
Sliding Clasp Bracelet  
Open locking plate. Move clasp to desired bracelet length. Exert pres-  
sure while holding locking plate and slide clasp back and forth until it  
engages in grooves on underside of bracelet. Press locking plate down  
until it snaps closed. Clasp can be damaged if excessive force is used.  
Foldover Clasp Bracelet  
Find spring bar that connects bracelet to clasp. Using a pointed tool  
(Fig. 1), push spring bar in and gently twist bracelet to disengage.  
Determine wrist size, then insert spring bar in correct bottom hole  
(Fig. 2). Push down on spring bar, align with top hole and release to  
lock in place (Fig. 3).  
Fig. 1  
Fig. 3  
Fig. 2  
BRACELET LINK REMOVAL  
Removing Links: Place bracelet upright  
and insert pointed tool in opening of link.  
Push pin forcefully in direction of arrow until  
link is detached (pins are designed to be dif-  
ficult to remove). Repeat until desired number of links are removed.  
Reassembly: Rejoin bracelet parts. Push pin back into link in opposite  
direction of arrow. Press pin down securely into bracelet until it is flush.  
SOLID LINK BRACELET  
Removing Links: Using a very small  
screwdriver, remove screws by turning  
counterclockwise. Repeat until desired  
number of links are removed. Do not  
remove links adjacent to clasp.  
Reassembly: Rejoin bracelet parts and insert screw in end of opening  
where it was removed. Turn screw clockwise until tight and flush with  
bracelet.  
(continued on reverse)  
 

Timex Heart Rate Monitor W265 User Manual
Toshiba Car Satellite Radio System L30W B User Manual
Toshiba Cell Phone G710 User Manual
Toshiba Computer Drive MK4018GAP User Manual
Transcend Information Computer Drive 25M User Manual
Trimble Outdoors GPS Receiver SPSX51 User Manual
Tripp Lite Switch B126 2X2 User Manual
UNICOM Electric Network Card POE 22001T User Manual
Universal Remote Control Universal Remote UR S475TVE User Manual
Venturer Portable DVD Player PVS1262 User Manual